Too much break tension on vinyl film causes the print to curl. This leads to edge de lamination.

Solution: Cover-Rite V2

Necking from excess brake tension causes the vinyl to distort and shrink. (When Decaling, this exposes the mounting adhesive, resulting in wrapping the rollers or damaging them.)

Solution: Cover-Rite V2

Image distortion and elongation make mounting difficult without stretching or skewing. This typically requires you to premask the vinyl decal.

Solution: Cover-Rite V2

Applying a conventional over-laminate requires constant monitoring of brake tension and windup clutch to facilitate ideal break point of
release liner. Most operators will set brake tensions too high.

Solution: Cover-Rite V2

Applying a premask after over laminating a decal requires the additional steps of removing the web, over laminating it, then reloading and re-webbing the premask; resulting in additional labor and material costs.

Solution: Cover-Rite V2

Traditional premasks make it difficult to see crop marks, trim lines and registration points. This makes positioning (alignment) of the decal to your mounting substrate difficult.

Solution: Cover-Rite V2

Have the need for SPEED ?
See below how Cover-Rite V2 eliminates countless steps!

1. Load the over-laminate onto the    laminator and web it up
2. Over-laminate the print
3. Un-web and remove the over-laminate
4. Load the premask onto the laminator and web it up
5. Premask the decal
6. Un-web and remove the premask
7. Mount the graphic and peel off the premask

1. Load the Cover-Rite V2 w/built-in premask and web laminator
2. Over-laminate the print and unweb
3. Mount the graphic and peel off the premask

Any Questions?

Cover-Rite V2 is available in 38 and 51 inch roll widths. To order, call 1-800-276-2664

To order call 800-276-2664